I would love to hear from you! Do not continue if power is present on a circuit breaker other than Service Disconnect or Main circuit breaker, until the power source has been shut off. Clean all foreign objects out of the panel and reinstall the cover. This article has also been viewedtimes. It finally makes sense why this works in the first place. Look for a blank area on the electrical panel that could accommodate a circuit breaker, paying particular attention to unused spaces at the top and bottom of the cover. Each tandem breaker provides 2 V circuits, this is true.
You may have to either remove the fan or rewire one of the sockets such that you're not putting too much current through open circuit breaker.
Electrical Panel Projects
If you are using a three prong receptacle as existing then the pigtail must be a three prong pigtail with the two outside wires of that pigtail connected to the two outside screws of the connecting block found in the dryer. Look for a blank area on the electrical panel that could accommodate a circuit breaker, paying particular attention to unused spaces at the top and bottom of the cover. Never oversize a breaker to solve a tripping breaker problem! Use your thumb to press firmly but gently on the circuit breaker until it snaps into place on the bus bar. Standing to the side of the panel, restore power to the panel by setting the Service Disconnect or Main to "On" and then set the new circuit breaker to "On".